Avaya J129 Installing And Administering page 104

Appendix
Parameter name
SLMSRVR
SLMSTAT
SNMPADD
November 2017 Installing and Administering Avaya J129 IP Phone in third-party call control setup
Default value Description
Specifies the IP address and the port number of
the SLA Mon server in the aaa.bbb.ccc.ddd:n
format.
Set the IP address of the SLA Mon server in the
aaa.bbb.ccc.ddd format to restrict the registration
of agents only to that server.
Specifying a port number is optional. If you do not
specify a port number, the system takes 50011 as
the default port. If the value of the port number is 0,
than any port number is acceptable.
The IP address must be in the dotted decimal
format, optionally followed by a colon and an
integer port number from 0 to 65535.
To use a non-default port, set the value in the
aaa.bbb.ccc.ddd:n format, where aaa.bbb.ccc.ddd
is the IP addressof the SLA Mon server.
0 Specifies if the SLA Monitor agent is enabled or
not.
Value Operation
0: Disabled (default)
1: Enabled
Null Specifies a list of source IP addresses from which
SNMP query messages will be accepted and
processed.
Comments on this document? infodev@avaya.com
Note:
If default port is not used, both the SLA Mon
agent and the server must be configured with
the same port. This parameter impacts the
phone's SLA Mon agent configuration. A
corresponding configuration must also be
made on the SLA Mon server agentcom-
slamon.conf file.
Note:
If default port is not used, both the SLA Mon
agent and server must be configured with the
same port. SLMSRVR impacts the phone's
SLA Mon agent configuration. A
corresponding configuration must also be
made on the SLA Mon server agentcom-
slamon.conf file
Table continues...
104