Analog Cv- And Gate-Outputs - Vermona '14 Analogsynthesizer User Manual

Analog CV- and GATE-outputs

The '14 Analogsynthesizer can send keyboard data (pitch and on/off-state) and its pitch- and
modulation wheel data as analog voltages. This way, it is possible to directly control analog
synthesizers from the good old days as well as modern eurorack-systems.
GATE OUT outputs the state of the key being pressed as GATE signal with a voltage of +10 V (tip)
as well as a control voltage for the modulation wheel (ring, 0-5 volts). The jacks are assigned as
follows:
ring
CV OUT outputs the control voltage of the key being pressed on the keyboard within a range of one
to five volts using the common one-volt-per-octave-characteristic (tip) as well as a control voltage
for the pitch wheel within a range of plus/minus 2.5 volts (ring). The jacks are assigned as follows:
76
tip
Figure 10:
ring
tip
Figure 11:
GATE OUT assignment
CV OUT assignment
Modulation Wheel
GATE
Pitch Bender
1V/Octave