Lfo-Synchronization - Vermona '14 Analogsynthesizer User Manual

LFO-synchronization

With EDIT parameter [9] LFO CLOCK SYNC being activated, the LFO's speed is synchronized to
the internal clock or an external MIDI-clock. Here, the FREQUENCY control adjusts a division- or
multiplication-ratio. Valid is the control's outer labeling. The eight subdivisions have the following
values:
Figure 6:
Carry out the following steps to enable/disable the LFO synchronization:
1. Make sure, the '14 Analogsynthesizer is in standard play-mode (ARPEGGIATOR switch
set to OFF).
Enter the edit mode by pressing the [EDIT] button – the corresponding LED will be lit.
2.
3. Use the select dial to select the EDIT parameter [9] LFO CLOCK SYNC.
Pressing the VALUE button activates or deactivates the LFO synchronization (activated if
4.
VALUE LED lit, deactivated if VALUE LED unlit).
Exit EDIT mode by pressing the [EDIT] button again.
5.
H
By activating
automatically disabled. Note, that it will not be reactivated when disabling the
synchronization.
A
In case the '14 Analogsynthesizer does not receive a MIDI-clock while external
MIDI-clock has been set as sync-reference, the LFO will stand still (see "Internal
clock and MIDI-clock" on page 71.
60
quarter triplet
quarter note
half note
whole note
division- and multiplication ratios with activated LFO-synchronization
LFO-synchronization,
eights note
eights triplet
1/16 note
1/32 note
EDIT parameter
i
[8] LFO-RESET is