Startup; Positioning; Audio Connections - Vermona '14 Analogsynthesizer User Manual

Startup

Please respect the following details while setting up your '14 Analogsynthesizer.

Positioning

To avoid scratches on furniture and the '14 Analogsynthesizer, the unit should be placed on a plain
surface with sufficient width and depth. Take care that the four foots underneath of the unit (not
the screws) touch the base.
Naturally, you may use the '14 Analogsynthesizer with a suitable keyboard stand.

Audio connections

The '14 Analogsynthesizer offers several monitoring possibilities:
Headphones: Located just below the pitch- and modulation wheels there are two headphone
-
outputs with 6.3-mm- respectively 3.5-mm-jacks
and can be used simultaneously. The level of both headphone outputs is commonly set using
the PHONES control in the VCA section
control for the line outputs.
Unbalanced jack output: Connect the '14 Analogsynthesizer to an unbalanced input, e.g. to a
-
mixing console or your computer's audio-interface, by using its jack-output on the unit's rear
labeled UNBALANCED
- Balanced XLR-output: Connect the '14 Analogsynthesizer to a balanced input by using
its male XLR-output labeled BALANCED
transformer for DC isolation of the audio signal. It is therefore predestined for use on
stage. So, along the way, the '14 Analogsynthesizer features a build-in high-quality DI-box.
The levels for UNBALANCED and BALANCED outputs are commonly controlled by the
VOLUME control in the VCA section
User Guide '14 Analogsynthesizer
. However, its level is independent from the level
r
.
d
d
.
r
. These are labeled with the symbol H
1!
. This output uses a specially designed
EN
45