Filter Modulation Vcf Mod; Pitchbender - Vermona '14 Analogsynthesizer User Manual

1. Make sure, the '14 Analogsynthesizer is in standard play-mode (ARPEGGIATOR switch
set to OFF).
Enter the edit mode by pressing the [EDIT] button – the corresponding LED will be lit.
2.
Use the select dial to select the EDIT parameter [7] VIBRATO WAVE: TRIANGLE.
3.
Activate or deactivate the triangle waveform by confirming with the VALUE button (activated
4.
if VALUE LED lit, deactivated if VALUE LED unlit – the vibrato generator uses a sine
waveform).
Exit EDIT mode by pressing the [EDIT] button again.
5.

Filter modulation VCF MOD

The VCF MOD section allows adjustments to the modulation intensity for the cutoff frequency and
filter FM by the modulation wheel and aftertouch.
The SOURCE switch sets the source that controls the intensity. Available choices are WHEEL
(modulation wheel), TOUCH (aftertouch) and BOTH (modulation wheel and aftertouch).
VCF FM INT adjusts the FM-intensity if modulated by the source (WHEEL, TOUCH) fully turned
up. The amount of FM intensity being set here is added the to the FM intensity being set in the filter
section. (see "Cutoff modulation" on page 55).
CUTOFF INT adjusts the intensity of the cutoff frequency if modulated by the source (WHEEL,
TOUCH) fully turned up.

Pitchbender

The pitchbender (pitch wheel) modulates the oscillators' pitch continuously upwards and downwards
The DESTINATION switch sets the modulation target. Available choices are VCO 1, VCO 2 and
BOTH. When set to BOTH, both oscillators are modulated equally by the pitchbender.
INT adjusts the intensity of the pitchbender. If set fully to the left, the amount is plus/minus a semi
tone. If set fully to the right, it is plus/minus one octave.
62
i