Mercedes-Benz C 230 1998 Owner's Manual page 84

Table of Contents

Advertisement

P 2 7 . 6 0 - 0 3 1 3 - 2 0
Selector Lever Positions
The autom atic gear shifting
process can be adapted to specific
operating conditions using the
selector lever.
P Parking position.
The parking position is to be
used w hen parking the vehicle.
Engage only with the car
stopped. The parking position is
not intended to serve as a brake
when the vehicle is parked.
Rather, the driver should alw ays
use the parking brake in addi­
tion to placing the selector lever
in park to secure the vehicle.
82
Note:
The electronic key can be
rem oved from the steering lock
only with the foot off the brake
pedal and the selector lever in
position " P". W ith the electronic
key rem oved, the selector lever
is locked in position "P".
R Reverse gear.
Shift to reverse gear only with
the car stopped.
N Neutral.
No power is transm itted from
the engine to the rear axle.
W hen the brakes are released,
the vehicle can be moved freely
(pushed or towed). Do not en­
gage " N" w hile driving except to
coast when the vehicle is in
danger of skidding (e.g. on icy
roads, see W inter driving
Instructions in Index).
Important!
Coasting the vehicle, or driving
for any other reason with se­
lector lever in " N" can result in
transm ission dam age that is not
covered by the M ercedes-Benz
Limited W arranty.
D The transm ission autom atically
upshifts to 5th gear. Position "D"
provides optim um driving
characteristics under all normal
operating conditions.
4 Upshift to 4th gear only. Suit­
able for perform ance driving. To
shift from position " D" to "4 ",
push selector lever to the left.
3 U pshift to 3rd gear only.
Suitable fo r m oderately steep
hills. Since the transm ission
does not shift higher than
3rd gear, this gear selection will
allow use of the eng in e 's brak­
ing power downhill.
2 U pshift to 2nd gear only.
For driving in m ountainous
regions or under extrem e
operating conditions. This gear
selection will allow use of the
engine's braking pow er when
descending steep grades.
1 In this position, the engine's
braking effect is utilized by
shifting into 1st gear. Use this
position w hile descending very
steep or lengthy dow ngrades
and only at speeds below
40 mph (60 km/h).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

C 280 1998

Table of Contents