W arning!
W hen program m ing a garage
door opener, the door moves
up or down.
W hen program m ing or op er
ating the rem ote control make
sure there is no possibility of
anyone being harm ed by the
m oving door._________________
Note:
Certain types of garage door
openers are incom patible with the
integrated opener. If you should
experience difficulties with pro
gram m ing the transm itter, contact
your authorized M ercedes-Benz
dealer or call M ercedes-Benz
C ustom er A ssistance C enter (in
the U.S.A. only) at 1-800-FOR-
M ERCedes.
74
Program ming or reprogram m ing
the rem ote control:
1. Turn electronic key in steering
lock to position 1 or 2.
2. Press and hold one button of
the remote control located on
the sun visor until its control
light begins to flash at a rate of
about once a second. Continue
holding down the button.
Note:
The light blinks im m ediately if
the remote control is being
program m ed for the first tim e, or
if its m em ory was previously
erased. If you are reprogram
ming a previously used button,
the light will flash after about
20 seconds.
3. Hold end opposite to battery of
portable remote control against
the sun visor transm itter to be
program m ed. W hile still holding
down the button on the trans
mitter on the sun visor, press
down the button on your port
able remote control, until the
sun visor rem ote control light
starts to flash rapidly. This
m eans that the integrated
rem ote control has accepted the
frequency and code of the
portable transm itter.
4. If you w ish, repeat the proce
dure fo r each rem aining button.
Operation of rem ote control:
1. Turn electronic key in steering
lock to position 1 or 2.
2. Select and press the appro
priate button (1, 2 or 3) to
activate the rem ote controlled
device. The rem ote control
transm itter continues to send
the signal as long as the button
is pressed - up to 20 seconds.
Erasing the rem ote control
memory:
1. Turn electronic key in steering
lock to position 1 or 2.
2. Sim ultaneousy holding down
buttons 1 and 3 fo r approxi
m ately 20 seconds, or until the
control light blinks rapidly, will
erase the codes o f all three
channels.