Install The Power Supply And Ac Terminal Block - Bosch ICP-MAP5000-2 Installation Manual

MAP5000
2.5

Install the Power Supply and AC Terminal Block

Caution!
Debris
!
Damage to the power supply due to debris during the installation is possible.
–
1.
2.
3.
Figure 2.5 Install the Power Supply
Refer to Figure 2.6 IPP-MAP0005 Power Supply Ratings Label, page 20 for the location of the
power supply ratings label. Refer to Technical Specifications, page 69 for power
specifications.
Bosch Sicherheitssysteme GmbH
To prevent damage to the power supply during installation, fit the supplied protective
dust cover label on top of the power supply before installing it.
Slide the left side of the power supply against the flange on the left side of the enclosure
back wall.
Align the cut-out on the right side of the power supply.
Secure the power supply to the enclosure back wall with the supplied hardware in the
following order: External tooth washer, Washer, Hex nut
ICP-MAP0110
Installation Manual
Installation | en
IPP-MAP0005
2
1
3
2014.12 | 13 | F.01U.168.332
19