34
en | Installation
Figure 2.21 Connect the Grounding Cable to the Hinged Mounting Plate
2.12
Install the ICP-COM-IF Relay Module
The ICP-COM-IF Module can be mounted on the hinged mounting plate or the mounting rails
of the MAP control panel enclosure.
A clearance of approx. 15 mm is required on either side for subsequent wiring. The terminal
plugs can be unplugged laterally.
1.
2.
2014.12 | 13 | F.01U.168.332
Attach the carrier plate of the ICP-COM-IF Module in the holes provided in the hinged
mounting plate or the mounting rails.
Use the screw provided to secure the carrier plate to the bottom rail.
Installation Manual
MAP5000
Bosch Sicherheitssysteme GmbH