Bosch ICP-MAP5000-2 Installation Manual page 62

62 en | Initial Set-Up and Programming
Report Failure Duress Alarm
Report Failure Hold-Up Alarm
Report Failure Intrusion and
Tamper Alarm
Report Failure Panel Alarm
Internal Tamper Alarm
External Tamper Alarm
Bypass
Disable
Management System Interface
Trouble
Present Mode ON
Blocking Time Active
Wrong Login
User Active
External Fire Alarm
Internal Fire Alarm
External Fire Trouble
Internal Fire Trouble
Walk Test
Motion Detector Test
Exit Delay Active
Entry Delay Active
Reportable Duress Alarm
Reportable Hold-Up Alarm
Reportable External Intrusion Alarm
2014.12 | 13 | F.01U.168.332
Panel has received negative acknowledgment from
Communicator due to Report Failure Duress Alarm
Panel has received negative acknowledgment from
Communicator due to Report Failure Hold-Up Alarm
Panel has received negative acknowledgment from
Communicator due to Report Failure Intrusion and
Tamper
Alarm
Panel has received negative acknowledgment from
Communicator due to Report Failure Panel Alarm
Tamper alarm from disarmed area
Tamper alarm from armed area
At least one device is bypassed
At least one device is disabled
Trouble in connection to management system
The area programmed as Present/Absent is disarmed
Blocking time is active for one or more areas
The maximum number of permitted passcode input
attempts on a control center was exceeded
A defined user is logged in at a defined control center
Fire alarm from armed area
Fire alarm from disarmed area
Fire device trouble from armed area
Fire device trouble from disarmed area
Walk Test is active
Motion Detector Test is active in one or more areas
From start of exit delay until
– end of exit delay
– arming of the area
From start of entry delay until
– end of entry delay
– disarming of the area
Reporting of duress alarm event
Reporting of hold-up alarm event
Reporting of external intrusion alarm event, possibly
also delayed if Present/Absent option is used
Installation Manual
MAP5000
Bosch Sicherheitssysteme GmbH