Install The Tamper Switch Rail - Bosch ICP-MAP5000-2 Installation Manual

16 en | Installation
4
5
See also
–
2.2

Install the Tamper Switch Rail

1.
2.
3.
Do not mount the tamper switch at this time.
Figure 2.2 Mount the Tamper Switch Rail
2014.12 | 13 | F.01U.168.332
Knockout for AC wires (use when AC wires come in from the back of the
enclosure)
Side wall knockouts for wiring
Remove the Enclosure Knockouts, page 15
Remove the tamper switch rail from the package.
Mount the tamper switch rail to the inner right side of the enclosure as shown in the
figure below.
Secure the tamper switch rail with the two supplied screws.
Installation Manual
MAP5000
Bosch Sicherheitssysteme GmbH