Installation Considerations; Plan The System - Bosch ICP-MAP5000-2 Installation Manual

MAP5000
1.3

Installation Considerations

–
–
–
–
–
–
–
Danger!
Danger of electric shock if live parts are touched. The alarm system is designed for an IT-
power distribution system (230 V). Switch off the power supply of the alarm system before
carrying out maintenance or installation work.
1.4

Plan the System

The ICP-MAP0110 Control Panel Enclosure is the main system enclosure. This enclosure is
designed to contain the following components:
–
–
–
–
–
–
–
Use the ICP-MAP0120 Expansion Enclosure when the system requirements for power and / or
other remote devices exceed the capacity provided by the ICP-MAP0110 Control Panel
Enclosure
The ICP-MAP0120 Expansion Enclosure is designed to contain the following components:
–
–
–
–
–
Use the ICP-MAP0115 Power Enclosure when system power requirements exceed the power
capacity of the ICP-MAP0110 Control Panel Enclosure
the following components:
–
–
–
Four batteries (40 Ah each)
This module mounts on the ICP-MAP0025 Hinged Mounting Plate.
1
This module mounts on the ICP-MAP0020 Accessory Mounting Plate, which mounts to the
2
back of the enclosure.
Bosch Sicherheitssysteme GmbH
When installing this system, ensure all local and national wiring codes are met.
Use only authorized service personnel to install this system.
Use only the installation material recommended by BOSCH Security Systems to ensure
error-free operation.
Follow anti-static procedures when handling system components. Ensure that you are
properly grounded to discharge any static charge before you work with system
components.
Install all components in dry, maintained interior rooms.
Install the system in a centrally located room that is near the AC Power MAINS.
Because the panel is permanently connected equipment, a readily accessible disconnect
device must be included into the building installation wiring.
ICP-MAP5000 Main Panel
ICP-MAP0007 DE Module
ICP-MAP0010 LSN Gateway
AT 2000 Communicator
IPP-MAP0005 Power Supply
ICP-MAP0065 AC Terminal Block
ICP-MAP0050 Control Panel Enclosure Tamper Switch
6
IPP-MAP0005 Power Supply
ICP-MAP0010 LSN Gateway
ICP-MAP0065 AC Terminal Block
ICP-MAP0055 Expansion Enclosure Tamper Switch
Two batteries (18 Ah each)
IPP-MAP0005 Power Supply
ICP-MAP0065 AC Terminal Block
ICP-MAP0050 Control Panel Enclosure Tamper Switch
1
1
1
2
3
4
3
5
4
3
4
Installation Manual
Introduction | en
6 . This enclosure is designed to contain
2014.12 | 13 | F.01U.168.332
7