Install And Connect The Its-Map0008 Wireless Modem - Bosch ICP-MAP5000-2 Installation Manual

36 en | Installation
2.13

Install and Connect the ITS-MAP0008 Wireless Modem

Figure 2.23 Install and Connect the ITS-MAP0008 Wireless Modem
The ITS-MAP0008 Wireless Modem is mounted on the enclosure back wall by means of two
screws (supplied with the enclosure). (Refer to Figure 2.23 Install and Connect the ITS-
MAP0008 Wireless Modem, page 36 for position). This means that there is no mounting location
for an LSA+ strip.
1.
2.
3.
4.
5.
Warning!
!
In order to avoid data loss on the SIM card, the wireless modem must be de-energized before
inserting or removing the SIM card.
2014.12 | 13 | F.01U.168.332
Insert the SIM card. Slide the card in from the top fully (card holder on the rear side of
the wireless modem) until it clicks into place. Pay attention to the insertion direction
(refer to Figure 2.23 Install and Connect the ITS-MAP0008 Wireless Modem, page 36).
Using the cable ICP-MAP0152, connect the 9-pin SUB-D plug to the COM 1 connection of
the ICP- MAP0007 DE Module (not supplied).
Connect the antenna to the FME female connector of the wireless modem.
Connect the black-red cable at output A or B of the power supply (terminal B = black,
terminal R = red), in addition to existing wires where appropriate.
Mount the small snap ferrite sleeve (contained in the accessory pack of the main panel)
on the black-red cable of the wireless modem close to the panel.
~
SIM
(-)
Installation Manual
ITS-MAP0008
ICP-MAP0152
(+)
Bosch Sicherheitssysteme GmbH
MAP5000