HART Loop Converter KFD2-HLC-Ex1.D(.**)
Configuration
4
Configuration
4.1
Configuration via Software
Danger!
Explosion hazard from sparking when plugging or pulling the adapter
Plugging or pulling the adapter in a potentially explosive atmosphere can cause sparks that
can ignite the surrounding atmosphere.
Only plug or pull the adapter in the absence of a potentially explosive atmosphere.
Caution!
Fault in the plant
Changing the device data changes the device function.
Before entering new device data, make sure the plant is not endangered by changing the
device data.
The devices can configured using the PACTware
Connection between Device and Computer
Connect the device and the computer using the K-ADP-USB adapter. This adapter can be
ordered as an accessory.
Connecting the Device to the Computer via the USB Interface
1.
Mount the device.
2.
Connect the device to the power supply.
3.
Connect the device to the PC via the adapter.
- Connection on the device: front programming socket
- Connection on the PC: USB interface
4.
Refer to the "Installation and Configuration DTM Collection Conventional Interface
Introduction" manual for further steps.
TM
operating software.
EN
EN - 25