HART Loop Converter KFD2-HLC-Ex1.D(.**)
Dismounting, Maintenance, and Repair
Disconnecting Circuits
1.
Disconnect the field circuit.
2.
Disconnect the control circuit.
3.
Disconnect the power supply.
Removing the Device
Use for dismounting of the device a slotted screwdriver
1.
Insert the screwdriver (4) into the groove of the red mounting slider (3).
2.
Turn the screwdriver (4) in the groove until the red mounting slider (3) springs back.
3.
Repeat these steps on the other side of the device.
4.
Remove the device (2) from the DIN mounting rail (1).
EN
EN - 57