Mounting And Installation; Configuration - Pepperl+Fuchs KCD2-UT2-1 Manual

Functional Safety KCD2-UT2-(Ex)1, HiC2081

Mounting and Installation

4 Mounting and Installation
Mounting and Installing the Device
1. Observe the safety instructions in the instruction manual.
2. Observe the information in the manual.
3. Observe the requirements for the safety loop.
4. Protect the device against manipulation. Mount the device in a lockable switch cabinet, for
example.
5. Connect the device only to devices that are suitable for this safety application.
6. Check the safety function to ensure the expected output behavior.
4.1

Configuration

Configuring the Device via PACTware Operating Software
The device can also be configured via the PACTware operating software. The interface for
connecting a personal computer for configuring is on the front of the device.
1. Open the cover.
2. Connect a personal computer via the K-ADP-USB adapter to the device.
3. Configure the device for the required safety function via the PACTware operating software,
see chapter 4.1.1.
4. Protect the device configuration by a password against changing.
5. Leave the parameterization mode to prevent unintentional adjustments.
6. Disconnect the personal computer from the device.
7. Close the cover.
8. Check the device configuration to ensure the expected output behavior.
9. Document any changes to the device configuration.
Note!
For more information see the manual.
4.1.1 Configuration for Use in Safety Function
Configuring the Device for Use in Safety Function
1. Configure the device for the required safety function via the operating software.
2. Disable the simulation function.
3. Enable the short circuit (SC) detection and lead breakage (LB) detection.
4. Disable the fault indication function > Hold.
5. Set the characteristic of the current output to the 4 mA to 20 mA NE 43 mode.
6. Protect the device configuration by a password against changing.
Note!
For more information see the manual.
14