Booting Process - H3C SecPath V100-E Installation Manual

The ventilation system works normally. You can hear that the fans are working and feel the flow of
the air.
The LEDs on the front panel are normal. Refer to LEDs for the LED description.
The console terminal display is correct. After powering up the V100-E, you can see the startup
window on the console terminal (see Booting Process). After the startup (or power-on self-test),
you are prompted to press Enter. When the prompt <H3C> appears, the system is ready for your
configuration.

Booting Process

After being powered up, the V100-E first runs the Boot ROM program. The terminal screen displays the
following system information.
The contents displayed on the terminal may vary with Boot ROM versions.
**************************************************
*
* H3C SecPath Series Gateway BOOTROM Version 1.27*
*
**************************************************
Copyright(C) 2004-2007 by Hangzhou H3C Technologies Co.,Ltd.
Compiled at Wed Oct 31 10:33:08 CST 2007
Testing memory...OK!
512M bytes DDR SDRAM Memory
16M bytes Flash Memory
Hardware Version is 2.0
CPLD Version is 1.0
Press Ctrl-B to enter Boot Menu
Press Ctrl + B right now and the system will enter the Boot menu. Otherwise, the system starts to read
and decompress the application program.
To enter the Boot menu, you need to press Ctrl + B within three seconds after the prompt information
"Press Ctrl-B to Enter Boot menu..." appears.
The terminal screen gives this information when the system starts decompression and initialization:
System is self-decompressing.....................
*
*
4-4