Maintaining Hardware; Preparing Tools; Opening The Chassis Cover - H3C SecPath V100-E Installation Manual

6

Maintaining Hardware

Preparing Tools

Phillips screwdrivers
Flat-blade screwdrivers
ESD-preventive wrist straps
Antistatic bags
None of the above installation tools are shipped with the device.

Opening the Chassis Cover

Follow these steps to open the chassis cover of the V100-E:
Step1 Power off the device and unplug the power cord.
Step2 Unplug all interface cables from the front panel while keeping the ground cable connected.
Step3 Put the device on a table with the rear panel facing you. Remove all the fastening screws on the rear
panel and both sides of the device with a Phillips screwdriver.
Step4 Lift the front of the cover to separate the front part from the chassis bottom.
Step5 Draw the cover toward you to separate the cover from the front panel and then put the removed cover
away.
Figure 6-1 shows how to open the chassis cover.
Figure 6-1 Open the chassis cover
(1) Remove six screws from these places
(1)
(1)
(2)
(1)
(2) Pull the cover out
6-1