Removing A Ddr Sdram - H3C SecPath V100-E Installation Manual

Figure 6-3 Location of the DDR SDRAM on the main board
Each DDR SDRAM has one positioning recess at its bottom for correct orientation. When installing a
DDR SDRAM into a memory bank, press the positioning recess into the pin in the bank.

Removing a DDR SDRAM

Follow these steps to remove the DDR SDRAM of the V100-E:
Step1 Locate the DDR SDRAM on the main board.
Step2 Pull the release latches away from the DDR SDRAM at both ends so that the memory is lifted from the
memory bank.
Figure 6-4 Remove the DDR SDRAM
Step3 Hold the DDR SDRAM by its non-conductive edge and separate it from the bank. Place the removed
memory module in an antistatic bag in view of protection.
6-4