Interface Cable - H3C SecPath V100-E Installation Manual

Table 8-8 LEDs on 1GEF and 2GEF modules
LED
LINK
ACT

Interface Cable

Ethernet cable
The 1GEF and 2GEF modules need to work with 1000Base-SX/1000Base-LX SFP optical transceivers
and optic fibers with LC-type connectors.
LC-type connectors are compact fiber-optical connecters with a latch mechanism developed by Lucent.
The optical fibers are optional accessories. To obtain these optical fibers, specify the SFP transceivers
when ordering an interface module.
Connecting the Interface Cable
When connecting an optical fiber, observe that:
The curvature radius should be not less than 10 cm (3.9 in).
The Tx and Rx ends are correctly connected.
The sectional surface of optical fibers should be clean and free from dust.
Laser is dangerous! Never stare into an optical fiber connectors directly.
Follow these steps to connect the optical fiber:
Step1 Install the optical transceiver in the SFP interface.
Step2 Distinguish between the Tx and Rx ports. Connect one end of an optical fiber in the Rx port of the optical
transceiver and the other end to the Tx port of the peer device. Use another optical fiber to connect the
Tx port of the optical transceiver and the Rx port of the peer device.
OFF means that no link is present.
ON means that a link is present on the interface.
OFF means that no data is being transmitted or received.
ON means that data is being transmitted or received.
8-12
Description