Table of Contents
Advertisement
MOPSlcdGX1 Product Manual
IDE Connector for 2.5 " Hard Disk (X5)
Pin
Signal
37
CS0#
39
NC
41
VCC
43
GND
13.2 Configuration
You can connect one or two IDE drives to the header by using an appropriate flat-ribbon
cable.
1. Configure the first drive as master.
2. Configure the second drive (at the end of the cable) as slave.
3. Consult your disk-drive manual for instructions.
The IDE interface offers several potential configuration settings. Refer to the
Configuration Submenu
on configuraton.
13.3 CompactFlash Connector (X14)
A CompactFlash socket for commercial CompactFlashes (Type I) is integrated on the
bottom side of the MOPSlcdGX1 board.
13.3.1 Configuration
You can use the CompactFlash card as a master device on the secondary IDE port.
Refer to the
I/O Device Configuration Submenu
chapter for information on configuraton.
Kontron Embedded Modules
Pin
Signal
38
CS1#
40
GND
42
VCC
44
NC
in the
Appendix B: BIOS Operation
25
IDE-Controller Interface
chapter for information
in the
Appendix B: BIOS Operation
Revision 1.3
I/O Device
Advertisement
Table of Contents
