Table of Contents
Advertisement
MOPSlcdGX1 Product Manual
15. ETHERNET-CONTROLLER INTERFACE
The MOPSlcdGX1 on-board Ethernet interfaces uses two
Ethernet
Controllers. The network controllers support a 10/100Base-T interface. The
device auto-negotiates the use of a 10Mbit/sec or 100Mbit/sec connection.
All major network-operating systems and several real-time and embedded-operating
systems support the interface.
The DM9102A provides:
• Integrated Fast Ethernet MAC, Physical Layer, and transceiver in one chip
• Compliance with PCI specification 2.2
• PCI bus-master architecture
• EEPROM 93C46 interface supports node-ID, access-configuration information
• Compliance with IEEE 802.3u 100Base-TX and 802.3 10Base-T
• Compliance with IEEE 802.3u auto-negotiation protocol for automatic link-type
selection
• Full-duplex/half-duplex capability
• Supports IEEE 802.3x full duplex flow control
• Digital-clock recovery circuit using advanced digital algorithm to reduce jitter
• High-performance 100Mbps-clock generator and data-recovery circuit
• Provides loopback mode for easy system diagnostics
Kontron Embedded Modules
Ethernet-Controller Interface
Davicom DM9102A PCI Fast
31
Revision 1.3
Advertisement
Table of Contents
