Adapter Cable Pinout - Kontron MOPSlcdGX1 Product Manual

MOPSlcdGX1 Product Manual
10.3.6 VBAT (System Battery Connection)
• This pin connects a system battery to all modules.
• The battery voltage has to be higher than 2.85V and lower than 3.15V. Kontron
Embedded Modules recommends a 3V battery (for example, CR2032).
Note: There is no battery needed to hold CMOS-setup data. Your configuration
information is saved in an onboard Ferroelectric Random-Access Memory (FRAM.)
However, you need a battery to run the CMOS date and time when power
consumption is off.
10.3.7 POWERGOOD (Reset Input 2)
• Input on CPU modules
• Open collector output on all other modules
• When POWERGOOD goes high, it starts the reset generator on the CPU module
to pull the onboard reset line high after a valid reset period. You also can use this
pin as a low active hardware reset for modules.

10.4 Adapter Cable Pinout

6 PIN MINI-DIN FEMALE
(PS/2 STYLE)
6
(+5V Vcc)
4
2
5 PIN DIN 180°
(DIN41524) FEMALE
3
5
Kontron Embedded Modules
(KLCK)
5
(GND)
3
1
(KDATA)
(Speaker)
1
(KLCK)
4 (GND)
2
(KDATA)
(+5V Vcc)
(POWERGOOD)
(RESIN)
(/KLOCK)
(VBAT)
20
Keyboard and Front-Panel Interface
Revision 1.3