Festo CPX Series Electronic Manual page 81

3. Commissioning
2:CPI:C
L1/M0: CPV10−GE−FB−..
L1/M0: CP−E16−M12/.
L2/M1: ...
...
1
Inputs and outputs of the selected CP module
Fig. 3/5: CP modules submenu Observing the signal states of a specific CP module
Festo P.BE−CPX−CP−E N en 0405NH
. 2:CPI(L1/M0):V10
Monitoring/Forcing (M)
Diagnostics (D)
Parameters (P)
Fail safe (F)
...
Forcing", Idle mode" and Fail safe"
Warning
The actuators connected can move unexpectedly!
Modification to the signal states and parameters with the
handheld can trigger dangerous movements of the con
nected actuators.
Make sure that nobody is in the positioning range of the
·
connected actuators and be very careful with the
parametrising and the manipulation of signal states.
It is imperative that you observe the notes on forcing,
·
idle mode and fail safe in the CPX system manual and in
the manual for the handheld.
You can also call up the Forcing" function via the Monitor
ing ..." menu. This function allows you to force signal states
during the commissing phase for test purposes.
The same representation of the CP modules applies commen
surately to the Idle mode" and Fail safe" functions.
. 2:CPI(L1/M0):V10:M
L1/M0: V10
0........................7
O00..07
O00..07
1
.
3−29