Festo CPX Series Electronic Manual page 60

3. Commissioning
CPX field bus node/CPX−FEC
CPX field bus node or CPX−FEC
with Remote I/O operating mode:
System parameter System start"
( [System start] ):
System start with default parameterisation
and current CPX equipment status ( [Default
parameters] ), factory setting
CPX field bus node or CPX−FEC
with Remote I/O operating mode:
System parameter System start"
( [System start] ):
System start with saved parameterisation
and saved CPX equipment status" ( [Saved
parameters] )
CPX−FEC with Stand Alone or Remote Controller
operating mode
Tab. 3/1: Saving the string assignment
3−8
Accepting the address range
The modified address range of the CPX−CP inter
face is automatically accepted.
1. Change system parameter System start..." to
... Default parameterisation ...".
2. Switch the power supply of the CPX terminal
off and back on. This automatically accepts
the modified address range of the CPX−CP
interface.
3. If necessary, you can restore the desired
parameterisation.
To accept the address range of the CPX−CP
·
interface, the actual configuration must be
saved as the set configuration (actual−nominal
comparison). You will find information on this
in the manual for the CPX−FEC or for the
software package FST 4.1.
Please note
After saving the string assignment, check the address
assignments of your CP system before starting user
programs.
Festo P.BE−CPX−CP−EN en 0405NH