Replacing A Complete Module Or Manifold Sub-Base - Festo CPX Series Electronic Manual

2. Fitting

2.2.1 Replacing a complete module or manifold sub-base

1 Tie rod groove
2 Tie rod
Fig. 2/1: CPX terminal (rear view)
Festo P.BE-CPX-SYS-EN en 0112NH
The manifold sub-bases are connected to each other mechan-
ically by means of two tie rods. The tie rods are situated in a
groove in the housing open at the rear.
1 2
Proceed as follows in order to remove a complete module or a
manifold sub-base:
1. Dismantle the CPX terminal.
2. Unscew and remove completely the tie rod screws in the
left-hand end plate (see Fig. 2/2). The manifold sub-bases
are held together by the electrical plug connectors.
2-7