Festo CPX Series Electronic Manual page 71

3. Installation
Festo P.BE-CPX-SYS-EN en 0112NH
Preparing the connecting cable
Caution
The position of the pins on the plug is different from that
on the socket.
– Pin assignment of the field bus interface see manual for
the "CP field bus node."
– Pin assignment of the sensor and actuator connections
of input and output modules see manual "CPX I/O
modules."
– The operating voltage and load voltage connections are
in the form of plugs. The pin assignment can be found in
the following chapters.
Use plugs and sockets from the Festo range which match the
outer diameter of the cables used.
Cable outer diameter
4.0...6.0 mm
6.0...8.0 mm
10.0...12.0 mm
Table 3/1: Plugs and sockets from the Festo range
Connection
Power supply socket
Field bus connection
*) The plug for the field bus connection depends on the field bus
node used (see manual for field bus node).
Table 3/2: Connections and plugs/sockets
Plugs/sockets
PG7
PG9
PG13.5
Plugs/sockets
PG9 or PG13.5
*)
3-5