Festo CPX Series Electronic Manual page 72

3. Installation
Preparing the plugs
and cables
1 Cables
2 Strain relief
3 Housing
4 Connecting part
Fig. 3/1: Individual parts of the socket and cable exit
3-6
Connect the plugs and cables as follows (example):
1. Open the plugs/sockets as follows:
Power supply socket:
•
Insert the mains power socket into the operating volt-
age connection of the CPX terminal. Unscrew the
housing of the socket.
Then remove the connecting part of the socket which
is inserted in the operating voltage connection.
Field bus socket and sensor plug (only with PG..):
•
Loosen the centre knurled nut.
1
4
2. Open the strain relief on the rear part of the housing.
Then pass the cable through.
3. Remove 5 mm of insulation from the end of the cable and
fit end sleeves on the strands.
4. Connect the ends of the conductor.
2
3
Festo P.BE-CPX-SYS-EN en 0112NH