Fitting - Festo CPX Series Electronic Manual

2. Fitting

Contents of this chapter
Further information
Festo P.BE-CPX-SYS-EN en 0112NH
The CPX terminal is already assembled when supplied from
the factory. If you wish to add or remove electric modules,
you must fit or remove further manifold sub-bases. This
chapter describes how to fit and remove manifold sub-bases
as well as how to assemble and dismantle a complete CPX
terminal.
Please refer to the following manuals if you wish to replace
individual electronic modules or sub-bases, or replace and
add pneumatic components:
– "Manual for the I/O modules" for fitting and removing the
module electronics and the sub-bases.
– "Pneumatics manual" for fitting and removing the pneu-
matic modules and components.
– The fitting instructions supplied with the product in the
case of modules and components ordered at a later
stage.
2-3