Bottom Cover Removal And Re-Installation; Figure 3-1: Bottom Cover Retention Screws - IEI Technology ITG-100AI User Manual

Qualified Personnel: The ITG-100AI must be installed and operated only by

trained and qualified personnel. Maintenance, upgrades, or repairs may only
be carried out by qualified personnel who are familiar with the associated
dangers.
Air Circulation: Make sure there is sufficient air circulation when installing

the ITG-100AI. The ITG-100AI's cooling vents must not be obstructed by any
objects. Blocking the vents can cause overheating of the ITG-100AI. Leave at
least 5 cm of clearance around the ITG-100AI to prevent overheating.
Grounding: The ITG-100AI should be properly grounded. The voltage feeds

must not be overloaded. Adjust the cabling and provide external overcharge
protection per the electrical values indicated on the label attached to the back
of the ITG-100AI.

3.3 Bottom Cover Removal and Re-installation

Before installing or maintaining the internal components, the bottom cover must be
removed from the ITG-100AI. Follow the steps below to complete the task.
Step 1: Remove the bottom panel by removing the four retention screws from the
bottom cover (Figure 3-1).

Figure 3-1: Bottom Cover Retention Screws

Step 2: Gently lift the cover to remove it.
Page 12
ITG-100AI Embedded System