Table of Contents
Advertisement
ITG-100AI Embedded System
Step 8:
Reinstall the bottom panel to the ITG-100AI by following the instruction
described in Section 3.3.
3.5 Wireless LAN Module Installation (Optional)
The ITG-100AI has an M.2 slot for WLAN card installation. The M.2 card slot is located
under the accelerator card. To install the optional wireless LAN (WLAN) module, please
follow the steps below.
Step 1:
Remove the bottom cover from the ITG-100AI. Please follow the instruction
described in Section 3.3.
Step 2:
Remove the accelerator card by removing the two retention screws as shown
below.
Figure 3-5: Accelerator Card Retention Screws
Step 3:
Locate the M.2 card slot (Figure 3-6).
Page 15
Advertisement
Chapters
Table of Contents
