Bottom Surface Re-Installation; Wireless Lan Module Installation (Optional); Figure 3-3: Bottom Surface Installation; Figure 3-4: Knockouts For Wireless Antenna - IEI Technology IDS-310-AL User Manual

3.3.1 Bottom Surface Re-installation

To re-install the bottom surface, insert the two screw holes in the bottom surface into the
two studs inside the chassis first, so that the bottom surface can be positioned correctly
and installed easily.

Figure 3-3: Bottom Surface Installation

3.4 Wireless LAN Module Installation (Optional)

To install the optional wireless LAN (WLAN) module, please follow the steps below.
Step 1: Remove the bottom surface. See Section 3.3.
Step 2: Remove the two knockouts for antenna installation. The two knockouts are
located on the rear panel of the IDS-310-AL as shown in Figure 3-4.

Figure 3-4: Knockouts for Wireless Antenna

Page 16
IDS-310-AL Embedded System