Transport, Storage, Maintenance, Disposal - Pilz PMCprimo Drive2 Installation Manual

11 Appendix
11.3

Transport, storage, maintenance, disposal

Transport:
Storage :
Maintenance: — the instruments do not require any maintenance
Cleaning :
Disposal :
Installation manual PMCprimo Drive2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
— only by qualified personnel
— only in the manufacturer's original recyclable packaging
— avoid shocks
— temperature –25 to +70°C, max. 20°C / hour rate of change
— humidity max. 95% relative humidity, no condensation
— the PMCprimo Drive2 contains electrostatically sensitive components which can
be damaged by incorrect handling
Discharge yourself before touching the PMCprimo Drive2. Avoid contact with
highly insulating materials (artificial fabrics, plastic films etc.).
— Place the PMCprimo Drive2 on a conductive surface.
— if the packaging is damaged, check the unit for visible damage.
— In this case, inform the shipper and the manufacturer.
— only in the manufacturer's original recyclable packaging
— the PMCprimo Drive2 contain electrostatically sensitive components which can be
damaged by incorrect handling
Discharge yourself before touching the PMCprimo Drive2. Avoid contact with
highly insulating materials (artificial fabrics, plastic films etc.),
Place the PMCprimo Drive2 on a conductive surface.
— max. stacking height 8 cartons
— storage temperature –25 to +55 o C, max. 20°C/hr. rate of change
— humidity relative humidity max. 95%, no condensation
— storage duration < 1 year without restriction
> 1 year : capacitors must be re-formed before
the PMCprimo Drive2 is commissioned.
To re-form, remove all electrical connections, and
supply the PMCprimo Drive2 for about 30 min. from
230V AC, single-phase, on terminals L1 / L2.
— opening the enclosure invalidates the warranty
— if the casing is dirty, clean with Isopropanol or similar cleaning agent
Do not immerse or spray.
— dirt inside the unit must be cleaned by the manufacturer
— dirty protective grill (fan) may be cleaned with a dry brush
— the PMCprimo Drive2 can be reduced to its principal components by removing
the screws (aluminium heat sink and front panel steel housing sections,
electronics boards)
— disposal should be carried out by a certified disposal company.
Page 93