Digital Enable Input (X3) - Pilz PMCprimo Drive2 Installation Manual

9 Interfaces
9.7.3

Digital ENABLE input (X3)

The output stage of the PMCprimo Drive2 is activated by the enable signal (terminal X3, Pin 15,
input 24V, active high).
In the inhibited state (low signal) the motor which is attached does not have any torque.
•
Reference ground is digital-GND (DGND, terminal X3, Pin 18)
•
Logic is PLC compatible
•
H-level: +12 ... 30V / 7 mA
•
L-level: 0 ... 7V / 0 mA
•
The digital input is electrically isolated through optocoupler
Installation manual PMCprimo Drive2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Page 61