Conductor Cross-Sections; Led-Display - Pilz PMCprimo Drive2 Installation Manual

7.9.3

Conductor cross-sections

Following EN 60204 (for AWG: table 310-16 of the NEC 60°C or 75°C column), we recommend:
AC connection
DC-link
Motor cables up to 25 m length
Motor cables 25 to 100 m length
Resolver, thermostat-motor
HIPERFACE Encoder, thermostat-
motor
Analog In- and outputs, AGND
Control signals, BTB, DGND
Holding brake (Motor)
+24 V / XGND
24 V (X10) EGND / VCC Enc.
7.9.4

LED-Display

A 3-character LED displays the servo amplifiers firmware version after switching on the 24V supply
for two seconds (e.g. "2.46").
Afterwards the status of up to 10 axes is shown (or just "run").
When an error occurs the error number is displayed (⇒ S. 83 ).
Page 22
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PMCprimo Drive2 sz. 01-10 : 1,5 mm²
PMCprimo Drive2 sz. 14/20 : 4 mm²
PMCprimo Drive2 sz. 01-10 : 1,5 mm²
PMCprimo Drive2 sz 14/20 : 4 mm²
PMCprimo Drive2 sz. 01-10 : 1 - 1,5mm²
PMCprimo Drive2 sz. 14/20 : 2,5 mm²
PMCprimo Drive2 sz. 01-10 : 1 mm²
PMCprimo Drive2 sz. 14/20 : 2,5 mm²
8x0.25 mm² twisted pairs, shielded, max.100m,
capacitance <120pF/m
10x0.14 mm² twisted pairs, shielded, max.100m,
capacitance <120pF/m
0.25 mm² , twisted pairs, shielded
0.5 mm²
min. 0.75 mm², shielded, check voltage drop
max. 2.5 mm², check voltage drop
2
Max. 1 mm , check voltage drop
600V, 105°C, twisted
shielded for length >
20 cm
shielded,
capacitance<150pF/m
shielded with motor
choke MD400
Installation manual PMCprimo Drive2
7 General