Table of Contents
Advertisement
8.5.4
LED Display
The LED display will show the menu for changing the parameters:
8.5.5
Automatic detection in PMCprimo
For automatic detection of a new drive no special change in the firmware is necessary.
Inside the autostart sequence it is determined if a new drive is in the cabinet.
This can be done for example with reading the serial number of the drive.
Example:
AS AUTOSTART
ES AUTOSTART
CH0.1
$SER1="SERIALNO"
IF($SER1!=$SER1ACTUAL);XS DRIVE_0;$SER1ACTUAL=$SER1;SP2
NS
The sequence gets the actual serial number and compares it with the last saved number. If there is
a difference then it calls the drive sequence which adjusts all parameters. Then it stores the new
serial number. Therefore the drive parameters are stored only once.
Page 44
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
to
to
to
to
to
Save parameters in Flash
to
Operating mode
CAN node number
Baud rate
KP speed control
Installation manual PMCprimo Drive2
8 Installation
Hide quick links:
Advertisement
Table of Contents
