5865-3 / 5865-4 Led Annunciator Installation - Honeywell 6808 Installation And Operation Manual

Wire dry contacts as shown in Figure 4.33. Notice grouping of terminals; power terminals are shared by two inputs.

4.10 5865-3 / 5865-4 LED Annunciator Installation

The 5865-3 and 5865-4 are LED annunciators. The 5865-4 has 30 mappable LEDs, remote silence and reset key switches, and a general
system trouble LED. The 5865-3 has 30 mappable LEDs only. These are arranged as 15 pairs of red (typically used for alarm) and yel-
low (typically used for trouble) LEDs.
Installation of the 5865-3 and 5865-4 is identical. The key switches and the trouble LED follow the behavior of other system annuncia-
tors and do not require any installation steps. The following sub-sections describe how to install the 5865-3 and 5865-4 hardware. Refer
to Section 9 for programming information.
NOTE: This manual uses "5865" when referring to aspects of the 5865-3 and 5865-4 that are common to both models.
Numbers indicate
point numbers for
5865. (They do
not appear on board
assembly.)
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Figure 4.33 Dry Contact Wiring
Plexiglass plate mounted to LED board at factory.
1 2 21 22
11 12
24
14 23
3 4 13
5 6 15 16 25 26
27 28
7 18
8 17
9 10 29 30
19 20
5865-4 Board Assembly
Figure 4.34 5865-3 and 5865-4 Assembly (front view)
Supervised/Power Limited
Do not remove.
5865-4 switches
SILENCE
follow main FACP;
no installation
TROUBLE
or programming
required.
RESET
Control Panel Installation
4.7k EOL
5865-3 Board Assembly
45