2: Output Circuit Mapping; 3: Event Mapping - Honeywell 6808 Installation And Operation Manual

8.2.2 Output Circuit Mapping
Figure 8.3 is a simple example showing how to assign notification and relay output circuits to groups. For an example of a simple floor
above/floor below application, see Figure 8.5.
8.2.3 Event Mapping
There are 11 types of Zone events, 14 types of Panel events, and 6 types of Site events that can be mapped (see Table 8-1). For each
event type, you can activate the output groups with specific output patterns. Mapping examples are shown in Figure 8.4, Figure 8.5, &
Figure 8.6.
System
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Figure 8.3 Assigning Output Circuits to Groups (Example)
Zone
Manual Pull Alarm
Water Flow Alarm
Detector Alarm
(heat or smoke detectors)
Zone Aux 1 Alarm
Zone Aux 2 Alarm
Interlock Alert
Interlock Release
Pre-Alarm
Fire Supervisory
Status Point
CO Alarm
CO Supervisory
Table 8-1 Event Types
Panel
System Aux 1 Alarm
System Aux 2 Alarm
Programming Overview
Site
Fire Drill
General Fire Alarm
General Fire Supervisory
General Fire Pre-Alarm
85