Table of Contents
Advertisement
2.5.1 Power Ratings
When mains is disconnected, the maximum current drawn by the panel from the batteries is 0.7 A in the quiescent condition and 6.97 A in the alarm condition.
The current value may vary as per the load conditions.
FOR PRIMARY POWER CABLE CONNECTIONS, THE USE OF RIGID CONDUIT IS REQUIRED.
3
Installation
3.1 Installation Procedure
Perform the following steps to install the fire alarm control panel:
1. Unboxing the panel
•
Remove the panel from the package and check the product completely before you discard the packaging box.
•
Check the product to see if any damage has occurred during the transit.
•
If there is no damage, then proceed with the installation .
•
If the product is damaged, return to supplier, re-using the same package wherever possible. Include written details of the damage.
Fig. 2: Checking for damage
NS-MN-0030 / 11.2020
Installation Guide SMX-AUS
11
Advertisement
Table of Contents
