Table of Contents
Advertisement
3.14.2 Model SK-5235 Remote Annunciator
The SK-5235 performs all system operation. It also provides trouble and alarm information
and can be used for programming. The control panel can support up to six SK-5235 Remote
Annunciators.
Upon initial power up, the address of each SK-5235 is displayed on the LCD. (Annunciators
with address 0 will not be supervised.)
3.14.2.1 Mounting the SK-5235 Remote Annunciator
The SK-5235 Remote Annunciators must be mounted on a dual gang electrical box.
To mount the annunciator:
1. Remove the rear mounting plate by inserting a #4 flat blade screwdriver into the slots on
the bottom edge of the annunciator. See Figure 3-11. Gently turn the screwdriver until the
mounting plate pulls away from the frame.
2. Secure it to the wall using #6 or #8 screws. The mounting plate should be oriented so that
the word TOP is toward the top of the plate and facing you. A square hole is provided in
the mounting plate to run the wiring to the annunciator.
3. When all of the wires have been connected to the annunciator, set the top of the
annunciator over the tabs on the top of the mounting plate. Make sure the wires do not get
pinched between the frame and the mounting plate. Press each corner of the bottom side
onto the annunciator mounting plate until you hear it click. You may have to gently
squeeze the annunciator (top to bottom) to align it while snapping the bottom edge into
place.
P/N 151204
Figure 3-11 Rear Mounting Plate Removal
firealarmresources.com
Control Panel Installation
3-21
Advertisement
Table of Contents
Troubleshooting
