4: Computer Access; 5: Access Codes - Honeywell 6808 Installation And Operation Manual

4. If the Network Panel ID is changed and valid, the system will ask you to confirm the change. If it is not correct, you can change the
dip switches at this time.
5. Press up to select YES and press ENTER to confirm.
6.2.4 Computer Access
An installer at the panel site can initiate communications between the panel and a computer running the HFSS Honeywell Fire Software
Suite (see also Section 8.2). In order for this communication to function properly, both the computer (running the software) and the con-
trol panel must have matching computer access numbers and computer codes.
To program computer access information:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 6 for Network Programming.
3. Press 4 to enter the Computer Access menu.
4. Enter the computer access number (up to 6-digits), then press ENTER.
5. Enter the computer code, then press ENTER.
6.2.5 Access Codes
Access codes provide the user access to the control panel functions. Each access code can be customized for each user. This allows some
users the ability to access programming and other higher level panel functions, while other users may only need access to lower level
functions such as preforming fire drills, or acknowledging trouble conditions.
Profile 1 is the profile that dictates what functions the Fire Fighter Key has access to. Because this is the profile for a key, the user name
and the access code can not be edited for this profile.
Profile 2 is the profile for the installer and is referred to as the "Installer Code". This profile's user name and panel functions can not be
edited. Table 7-9 lists the panel functions that can be selected for each user profile.
*Function Keys are only available on the LCD annunciator
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Type of Function
Panel Operations
Panel Menus
Table 6.1 : User Profile Selectable Panel Functions
Selectable Functions
System Reset
System Silence
System Ack
Fire Drill Key
*F1 Function Key
*F2 Function Key
*F3 Function Key
*F4 Function Key
System Tests
Fire Drill Menu
Indicator Test
Walk Test-No Report
Walk Test -With Report
Communicator Test
Clear History Buffer
Point Functions
Disable/Enable Point
Point Status
Set SLC Device Address
SLC Single Device Locator
SLC Multiple Device Locator
I/O Point Control
Event History
Set Time & Date
System Information
Network Diagnostics
Network Programming
Panel Programming
Send/Receive Firmware Update
Network Management
69