Table of Contents
Advertisement
Programming
4.
From the next menu, select 1 for Communication Options.
5.
Select 5 for Phone Line Gains
6.
The available options:
•
Dialing Gain:
•
Low = 9 DB Attenuation
•
Normal = 6 DB Attenuation
•
*High = 3 DB Attenuation
•
Reporting Gain:
•
*Low = 9 DB Attenuation
•
Normal = 6 DB Attenuation
•
High = 3 DB Attenuation
9.6.2 Time Options
Through this programming option you can set the water flow delay time, alarm verification time, AC report delay, AC-Frequency, Auto-
Resound, and Clock Format.
Water Flow Delay
You can program a delay of 0-90 seconds (zero means no delay) to be used in conjunction with a water flow switch. The delay is system-
wide. All water flow switches on the system will use the same delay period.
To access the screen for programming water flow delay, follow these steps:
1.
Enter the installer code.
2.
Select 7 for Program Menu.
3.
Select 5 for System Options.
4.
Press 4 for Time Options.
A screen similar to the one shown in Figure 9.9 will display.
5.
Enter the number of seconds (0 to 90) to delay an a water flow switch alarm, then press ENTER.
Alarm Verify
You can set the alarm verification time from 60 to 250 seconds (default is 60 seconds).
To set the alarm verification:
6.
Enter the desired number of seconds for the alarm verification time.
7.
Press the right arrow or ENTER to make your selection and move to the next programming option.
AC Report Delay
NOTE: You must select 1-3 hours in UL central station installations and UL remote signaling installations.
You can adjust the number of hours before a Low AC report will be sent to the central station.
To program low AC report delay, follow these steps:
110
Figure 9.9 Water Flow Delay Programming Screen
Delay in seconds
before waterflow
alarm occurs.
(00 - 90)
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Advertisement
Table of Contents
Troubleshooting
