2: 6860 Connection To The Panel; 5824 Serial/Parallel Interface Module Installation - Honeywell 6808 Installation And Operation Manual

4. Place the trim ring over the back box as shown in Figure 4.26.
5. Attach the door assembly to the back box using screws provided.
6. After the SBUS wiring to the annunciator is complete (described in Section 4.7.2), replace the electronic assembly in the back box.
Place the bezel over the back box and tighten the set screws on the bezel.
4.7.2 6860 Connection to the Panel
Connect the 6860 to the panel as shown in Figure 4.27

4.8 5824 Serial/Parallel Interface Module Installation

The 5824 serial/parallel interface module allows you to connect a printer to the panel. Printing is available for real time events, detector
status and event history. The 5824 and the printer connected to the 5824 are for ancillary use only. The printer must be a UL 864 listed
printer.
To install the 5824:
1. Make sure power is off at the panel.
2. Connect the 5824 to the panel as shown in Figure 4.28.
NOTE: Four 5824s per panel maximum.
3. Use the DIP switches on the back of the 5824 board to assign an ID# to the 5824 (see Section 4.11.1).
4. Configure the 5824 device through programming. See Section 4.8.1.
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Figure 4.26 Installing Trim Ring
Figure 4.27 Model 6860 Connection to the Panel
Control Panel Installation
41