Appendix B: Editing Text Using The Built-In Programmer; B.7: Characters Used For Editing Text; B.8: Example Name Edit - Honeywell 6808 Installation And Operation Manual

Appendix B: Editing Text Using the Built-In Programmer

This section contains tables of programmable characters that may be used for device, module, site, template, group, and zone names or
phone numbers. T9 style editing is used.
B.7 Characters Used for Editing Text
Table B.1 lists the available characters and their associated numeric designator. When programming:
1. Use the Up or Down arrow key to scroll to the mode wanted.
2. Press the number shown in Table B.1 until the character wanted is shown.
3. Arrow left and right for position, and press enter to accept.
B.8 Example Name Edit
1. Press the up or down arrow to select upper case letters mode, Press 2 until "F" appears.
2. Press the up or down arrow to change mode to lower case letters, Press 3 until "i" appears.
3. Press 6 until "r" appears.
4. Press 2 until "e" appears.
5. Press 0 to space, then continue to next word using the same process.
6. Press ENTER to accept.
NOTE: After three seconds of no change, letter will automatically be accepted. Also pressing next number will automatically accept previous
choice
158
Lower Case Letters
abc 1 def
mno 5 pqr
yz 9 Spc
Upper Case Letters
ABC 1 DEF
MNO 5 PQR
YZ 9 Spc
Numbers and Special Characters
[ ]
2 ( )
1 1
5 ' " 5 6 ? !
9 = - 9 0
Table B.1 Character Table
Figure B-1 Edit Name Example
2 ghi 3 jkl
6 stu 7 vwx
0
2 GHI 3 JKL
6 STU 7 VWX
0
2 3 . , 3 4 : ;
6 7 ' / 7 8 – +
0 * & @ * # $
6808 P/N LS10146-001SK-E:C 09/28/2017
4
8
4
8
4
8
#