Appendix 2 - Troubleshooting Guide; Led Indicator Guide - Normal Operating Mode - Honeywell HW-TG7LAF02 Installation And Operating Manual

Appendix 2 – Troubleshooting Guide
This section provides a summary of all LED indications and their meanings, as well as the expected behavior
of the Telguard under various exception conditions.
LED Indicator Guide – Normal Operating Mode
LED Symbol Color
LED 1 Activation Green
LED 2 STC
(System Trouble Red
Condition)
LED 3 MODE Yellow
LED 4
Acknowledgemen Red
t
LED 5 Radio Green
LED 6 Not used
LED 7 Trip Input Green
LED 8 AC Power Red
Note: * means that the LED will continuously flash.
LS10265-000HW-E:C 04/27/2021
Showing Indication
Solid On Unit is activated at the message center and enabled
Off Unit not activated at message center (and disabled)
Flash* Unit is disabled
Off ALL OK
1 Flash* System Trouble Condition – Low/Missing AC Power
System Trouble Condition – Low/Missing Battery Condition
2 Flashes*
AND/OR Battery Charger Failure
3 Flashes* System Trouble Condition – LFC
4 Flashes* System Trouble Condition – NSC
5 Flashes* System Trouble Condition – RFC
6 Flashes* System Trouble Condition – DTF
7 Flashes* System Trouble Condition – PPF
Off Alarm panel idle (Telguard is primary or Sole Path)
Flash *(1 sec) Alarm panel off-hook to transmit signals over cellular.
On Alarm panel idle (Telguard is backup)
Solid On The Telguard is waiting for acknowledgement from the TCC
Off Idle state
When flashing with LED 1, unit has failed activation due to
Flash* the programming of the panel, CALL TELGUARD TECHNICAL
SUPPORT
Off Telguard initialized
On Telguard initializing with cellular network
Flash (1 sec) Radio receiving message
Flash (2 sec) Radio sending message
Flash (2
flashes every Link Supervision Mode
6 sec.)
Solid On Trip Input activated
Off Trip Input not activated or restored
Solid On AC power connected to unit
25
firealarmresources.com
56052901 – Rev B