4.
Attach the annunciator and door assembly to back box as shown in Figure 4.18 using the supplied screws.
Surface Mounting
The optional Model RA-100TG/TR trim ring kit is available for use when surface mounting.
1.
Remove the desired knock out. See Section 4.5.
2.
To properly mount the back box, insert a single screw into the key shaped mounting hole. Do not tighten all the way. See
Figure 4.19.
Place a level on top of the back box, with the back box level insert the rest of the mounting screws.
6808 Manual — P/N LS10146-001SK-E:C 09/28/2017
Figure 4.18 Attaching Annunciator/Door Assembly to Backbox
Key Shaped
Mounting Hole
Figure 4.19 Back Box Surface Mount Holes
Back Box
Mounting Holes
Control Panel Installation
37