Honeywell Centraline FALCON User Manual page 258

FALCON
EN2Z-0962GE51 R0715
19. Check your email box for the received test email.
20. If the email test is successful, check E-Mail Feature Enabled.
Checking the E-Mail Alarming Eabled check box instantly enables the
controller sending emails when alarms occur.
NOTE: When firstly setting up the email alarming function, do not check this
option unless you have performed the email test. It is recommended to
check this option only when you are sure that the entered data are
correct and emails will be sent to the right recipient, by using the
existing and already tested ´email send path`.
Example:
Reuse of the established email send path after application
modifications and subsequent application download
21. On the E-Mail tab, change the E-Mail Send Repeat Time (Minutes) if desired.
After the time interval in minutes, entered here, the email is repeatedly sent to
the recipient. Check the Off checkbox, if you want to turn off the repeated
sending of emails, for example when using the Test E-Mail function. Turning off
the option may result in the loss of particular emails if the first attempt of
sending the email has failed.
22. In the tree, click Alarms, and then click E-Mail Alarming tab on the right to view
the email transmission result. Under Last E-Mail Transmission Result, the
following data are shown:
E-Mail Status
Shows the status of the last sent email, for example ´Send Email Successfully`
or ´Send Email Status Not Available`.
TimeStamp
Shows the date and time of the last email status.
Under E-Mail Alarm Send Queue, emails are listed which, for some reason,
have not been sent yet. The emails are shown with the following properties:
• To(Recipient)
Shows email address
• Subject
Shows <Alarm><datapoint name>
254
USER GUIDE