Honeywell Centraline FALCON User Manual page 199

USER GUIDE
To Fault
This option has no function.
Ackn.
Shows the Acknowledged status and allows acknowledgement.
The acknowledged status (checked or unchecked), firstly depends on the
Ack Required setting of the notification class in CARE. In CARE, for each
transition type you can define wthether an acknowledgement ist required or
not. Secondly, the possibility to change the Ackn. status depends on the
reporting status of the transition (enabled or disabled) here.
Last Transition
Shows the date when the last transition has occurred.
Event Parameters
• Event Type
The event type is ´change of state`.
• High Limit
Enter the high warning limit value.
• Low Limit
Enter the low warning limit value.
NOTE:
The warning limits can be below or above the high and low limit reporting
values.
• Deadband
Enter a deadband value. This defines an additional trigger to set off an
alarm. The event enrollment alarm is sent if the following condition is true:
present value must, for at least the defined time delay (time), remain within
the range: Low limit plus deadband and high limit minus deadband.
• Time delay
Enter a time delay in sec. The even enrollment alarm is sent if the present
value still increases or decreases the warning limits after the time entered
here has been elapsed.
For details on the options below, please refer to the datapoint desriptions in the
CARE User Guide.
3. Click SUBMIT button, and/ or viewing general information of the event
enrollment, clicki the General tab.
On the General the following information is displayed:
Properties
• Object Type
Defaults to event enrollment for all point types.
• Description
Shows the prefix of the event enrollment name as entered in CARE.
Access Rights
Shows the read and write access level of the event enrollment.
To write values to a datapoint, you must have a write access level equal or
higher than the write access level of the event enrollment.
Datapoint details will only be displayed if you have a read access level equal to
or higher than the read access level of the event enrollment.
4. Click SUBMIT button to save settings, and then click CLOSE button.
NOTE: The acknowledged transitions observation applies to all datapoint types.
195
Acknowledged Transitions Observation
EN2Z-0962GE51 R0715
FALCON