Related Manuals for Honeywell Ex-Or CDH8U5
Summary of Contents for Honeywell Ex-Or CDH8U5
- Page 1 CDH8U5 8-Channel Programmable Intelligent Lighting Control Module Product option shown here for illustrative purposes only Installation and Commissioning Instructions...
- Page 2 Introduction The CDH8U5 is an intelligent LCM providing connections for multiple luminaires*, up to 5 presence detectors and up to 10 SELV inputs. Provision Loads on Channel 1 is made for 7 switched live outputs plus one volt-free power output. The unit features a switched output for Maintained Live to allow initiation of Ballast...
- Page 3 External Connecting Switches Live in from Maintained same Phase shorting The CDH8U5 is equipped with SELV switch inputs which will typically be two Output Links Switched Live way, centre off, momentary rockers,(e.g. the MK K4900 range). The logical function of a switch can be configured from a wide range of options and its action can be associated with any combination of channels.
- Page 4 Easy integration of lighting and AV systems The AVINTCDR provides an interface between MLS Connect Digital Intelligent Lighting Control Module (i.e. CDW12U5-B, CDH4U5-B or CDH8U5-B) or from any Audio Visual system that uses Dynet commands via RS232 or RS485. When the Ex-Or interface receives a command from the AV system, the decoded signal is then sent to the CD Box where it is translated (a command can recall scenes 1 to 6 of a zone in the range 1 to 100) and can be forwarded on to the MLS Digital Network if connected to it.
- Page 5 Commissioning The LCM is commissioned using a dedicated programme running on a Windows-based computer. Commissioning settings may then be directly uploaded from the computer to the LCM or transferred to a QuickSet Pro hand-held programmer for easy upload on site. Communication from the PC can be by means of a USB infrared transceiver which can signal directly to the LCM’s on-board infrared port over a short range or via any attached presence detector from beneath (range: 1-3m).
- Page 6 Reconfiguring a CD BOX to DSI Operation To reconfigure a CD BOX to DSI: 1. Switch on the QuickSet PRo, the Home Screen is displayed. 2. Use the Right Arrow Key to navigate to the Products tab and press OK. This displays a screen listing available products. 3.
- Page 7 Connections View on top side of unit View on bottom side of unit Comms Bus (MLS) Volt-free Switched Mains Dimming Additional Switches Detectors Aux 1 Channels Live Outputs Input Channels Switches Technical Data Operational supply: 230VAC ~50Hz/60Hz Power consumption: 18W maximum Product rating &...
- Page 8 St. Marks Court, North Street, Horsham, West Sussex, RH12 1BW, UK Tel:+44 (0)1942 719229, Fax: +44 (0)1942 508753 Email: technicalsales.ex-or@honeywell.com www.ex-or.com At the end of their useful life the packaging and product should be disposed of via a suitable recycling centre.