Related Manuals for Honeywell CF4680
Summary of Contents for Honeywell CF4680
- Page 1 CF4680 2D Imager Module For Customer-Facing Designs Quick Start Guide CF4680-EN-QS Rev A 5/21...
-
Page 2: Required Accessories
What is the CF4680 2D Imager Module? The CF4680 is a 2D imager module designed to be integrated into fixed mount enclosures, such as a self-service kiosk. It includes: • N4680 scan engine • USB interface (USB-B connector) • Exit window •... - Page 3 CF4680 Front View Mounting holes (x4) Exit window...
- Page 4 CF4680 Back View Ribbon cable sensor to PCB Ribbon cable engine to PCB Movement detector Scan engine USB-B connector Distance selection switch User feedback pins...
-
Page 5: Pcb View
PCB View Flex connector to movement detector USB-B connector User feedback pins Distance selection switch Flex connector to scan engine... - Page 6 CF4680 and to the USB port on the host. Power-up the host. Verify that the CF4680 is on by presenting a bar code in front of the scan window. The white LED should turn on and read the bar code.
- Page 7 Distance Selection Switch Use this switch to select the range to be used to detect an object and trigger the scan engine. The distance is measured from the outside of the exit window. • Position 1—0 to 10 cm (4 in) •...
-
Page 8: Configuration Bar Codes
Configuration Bar Codes Scan configuration bar codes to set up your scanner. All avail- able configuration bar codes are available in the N4680/ CF4680 User Guide. Contact your local Honeywell OEM repre- sentative for more information. EZConfig for Scanning Tool... -
Page 9: Basic Setup
Basic Setup Here are some basic menu bar codes that may be useful for test- ing. For more setup options see the N4680/CF4680 User Guide (available from your local Honeywell OEM representative). Note: The * symbol indicates the default value. -
Page 10: Keyboard Country Layout
Keyboard Country Layout The default keyboard is United States. French German Italian All Symbologies All Symbologies On All Symbologies Off... -
Page 11: Led Illumination
LED Illumination Use this setting to change the LED illumination brightness. Low * Medium High Reset Factory Defaults The following bar code resets factory defaults. -
Page 12: Mechanical Dimensions
Mechanical Dimensions... - Page 13 Mounting hole recess (section A-A)
-
Page 14: Exit Window
User Feedback Pins User feedback pins give you access to the trigger, beeper and good read lines on the scan engine. See the CF4680 Installation Guide for details on these pins (available from your local Honey- well OEM representative). Exit Window The exit window is made of chemically strengthened glass and is scratch resistant. -
Page 15: Customer Support And Technical Assistance
If warranted goods are returned to Honeywell during the period of cover- age, Honeywell will repair or replace, at its option, without charge those items that Honeywell, in its sole discretion, finds defective. The forego- ing is buyer’s sole remedy and is in lieu of all other warranties,... - Page 16 The information we supply is believed to be accurate and reliable as of this writing. However, Honeywell assumes no responsibility for its use. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be pho- tocopied, reproduced, or translated into another language without the prior written consent of HII.